IP,0000,212.70.49.110,12071#

first ip,port (Pro)

IP2,0000,212.70.49.114,12032#

second ip2, port (IN)

2IP,0000,1#

mode to update in 2 server active parallel mode

APN,0000,afaqy.iot.zainsa,,#

Apn (zain)

REBOOT,0000#

reboot

FACTORYCLEAN,0000#

Clean the buffer data. A manual reboot(refer to command "REBOOT") is needed after sending this command.

STATUS,0000#

Read device current status: Network status, server login status, GPS status, inputs & outputs status, etc.

STATUS1,0000#

Read device current status: Attach status, Socket status, etc

CONFIG,0000#

Read the config information: Tracking mode, APN, IP, heartbeat, timer, Bluetooth, relay mode, ignition detection sauce, protocol type, etc.

CONFIG1,0000#

Read the config information: 2IP working mode, driver behavior, network scanning mode, etc.

CONFIG2,0000#

Read the config information: Network connection mode, message ACK setting, etc.

SIMINFO,0000#

Get SIM card IMSI and ICCID

HBT,0000,A#

Keep datalink alive (heartbeat) packet setting ---- 1. A, time period value. The unit is mintue. ---- 2. Range from 1-255 ---- 3. Default A=5

GOOGLE,0000#

Get tracker current location

REALTIMEFIRST,0000,A#

This command is to set the data sending priority (A=1, real time data first) (A=0, buffer data first) (Default A=0)

DMODE,0000,A#

A, device working mode /// A= 1, device will work in TCP mode /// A= 2, device will work in UDP mode /// A= 3, device will work in MQTT mode (only for 4G devices, 2G device doesn't support) /// Default A=1

TIMER,0000,A:B:C:D#

A, tracker reports every A seconds when ignition on (range is 0 or 3~65535. 0 means disable) /// B, tracker reports every B seconds when ignition off (range is 0 or 3~65535. 0 means disable) /// C, tracker reports when the vehicle turns every C degrees (range is 0~180, 0 means disable) /// D, tracker reports when the vehicle runs every D meters (range is 0~65535, 0 means disable)

PASSWORD,0000,A#

change the device password --- A, device password. Default password is 0000

RELAY,0000,0#

Engine ON

RELAY,0000,1#

Engine OFF

BLEIDA,0000,A,B#

Add a BLE sensor A=sensor ID --- B=sensor type (1=TSTH1-B, ...etc)

BLEIDD,0000,A,B#

Delete a BLE sensor A=sensor ID --- B=sensor type (1=TSTH1-B, ...etc)

BLERELAY,0000,A,B,C#

A=Relay ID --- B=Relay Password (654321) ---- C=0(disable)/1(enable)