.jpg)
.jpg)
.jpg)
.jpg)
Teltonika FMC130
- Fast position fix (Outdoor areas);
- High Quality track even in high density urban canyon;
- Ready for harsh environment;
- Firmly fasten;
- Real time tracking;
- Ignition or any other I/O event;
- Sending acquired data via GPRS;
- GPRS and SMS I/O events;
- Virtual odometer;
- Jamming detection;
- Configurable using Secured SMS Commands;
Pinout
Technical Specification
notes
- Teltonika FMC130 quad band module (4g connection)
- latest firmware version is 03.29.00.Rev.13, and we always upload latest firmware version
- Configuration files uploaded by Fota
- The device can be set up and managed via messaging, enabling control over various features and parameters through message-based commands.
- The device is equipped with Bluetooth connectivity, allowing for the connection of Bluetooth sensors and enabling control over them.
- Example: Bluetooth tzone
- You can check the I/O status using the following commands: getio
- Can check battery status through commands: battery
- For every command sent to the device, it responds with a corresponding reply.
- Digital input 2 mode : In Input Mode settings user can choose which configuration input will be use: DIN2/AIN1 or Ground Sense. If Ground Sense is selected, the input will act as an inverse Digital Input, where a low voltage level will output 1 using the Ground Sense I/O element, and a high voltage level will output 0.
- You can connect a LVcan200 (low-voltage CAN) interface to the device to enable it to read CAN bus messages from the vehicle. This setup allows for communication between the device and the vehicle's CANbus system, facilitating data retrieval and control functionalities.
- To enable Ter3 to read, we need to upload the following:
- Use Firmware FMB.Ver.03.29.00.Rev.731_ID1 (C130)
- Use Teltonika.Configurator_1.7.30_E.THS202_R.5
- enable the parameters
- Check out the following link: TeraCom
- Check the configurator at the following link: Configurator
- Check device led behavior on the following link: LED Behavior
- Reference configuration: fmc130-m2m-(110) ( weight & out& ble )
compatible sensors
Tzone TZ-BT04 bluetooth
TopFly Temperature and Humidity (TSTH1-B)
TopFly Door and Temperature (TSDT1-B)
TSH202 (TER3)
Load Sensor
Pressure Sensor
Buzzer
Door Sensor
immobilizer
Panic Button
I-Button
LV-CAN 200
